PUSH FRAME AND PLOW LIFT: Shall be Bonnell model HFF/SP quick Hitch with Bonnell-QAC coupler and Even Lift by telescoping lift arm. Side plate hitch type. The lifting device and push frame shall be constructed that a suitable power reversible type snowplow may be used. The push frame side plates shall not be less than 5/8″ thick and shall extend back as far as practical from the front end of the truck frame so as to reinforce the frame. Push frame shall have 11” ground clearance to bottom of push frame (Drawing included). Hitch shall be provided with a double acting hydraulic cylinder with nitrated rod of sufficient capacity to raise the plow specified. Hitch shall be compatible with plow Bonnell model 12TA3762MXIQA. Plow hitch shall be tilt type, if necessary, for access to engine compartment or fixed type, and shall have hydraulic cushion block for reversing cylinders installed. Unit shall have auxiliary ABL 3800 full LED combination drive lights with 5 integrated functions including directional signals and hardened glass lens. Auxiliary lights shall be hood mounted with Stainless Steel brackets, with spacing on 60″ centers (+/- 5″). Height shall be 75″ from ground to bottom of light. Auxiliary lights shall be controlled by switch on control box. High and low beam on both original and auxiliary unit will be controlled by original dimmer switch. Truck is supplied with stationary grill. Install “Load Share Air Bag” (P/N 6926) on right front suspension. 2 Heavy Duty Tow Hooks mounted on side plates of plow hitch. POWER REVERSIBLE SNOW PLOW: Shall be Bonnell model 12TA3762MXIQA (or comparable Per County Approval) reversing table and A frame, Painted Yellow (L6806EB) to match cab and chassis color. Cutting Edge Holes Standard AASHTO Punch for (2) 6 ft. cutting edges Cutting Edge Length 12 Feet Cutting Edge Material 3X FLEX Rubber-Encased Carbide Cutting Edge System Cutting Edge Bolts 5/8″ GR 8 Counter sunk Cutting swath at 35 degrees 9'9″ Cutting swath at 28 degrees 10'7″ Reversing Cylinder Two - 4″ Dia., 2″ nitrated rods, 12″ stroke Moldboard Material 10 gauge Moldboard Bottom Angle 4″ x 7″ x 3/4″ Carbide Frog Protector 2 (outsides) Moldboard Ribs Seven – 1/2″ x 3″ with the left one doubled (looking at the plow from the back) Level Raise Lift System Chains Springs 8 Flap Minimum height 16″, Anti-Sail Snow Plow Jack Swivel Jack, Top wind, 2,000 lbs. Lift Capacity Center/ground 10” Retracted. 10" Travel, Weld-On Tubular Mount (Bulldog part# TWS158DTSF) A-Frame Shall have gussets behind stops. QA Loop Welded to the lower side of plate.
