Specifications include, but are not limited to: Specifications for Aluminum Drop-Side Body Length- approximately 9-9.5 feet. Width- approximately 96 inches (8 feet). Both Sides: Drop down style, height approximately 14 inches. Single piece double-wall 1/8 aluminum minimum. Boxed extruded aluminum floor with smooth floor. Removeable double-acting tailgate, height approximately 16 inches. Reinforced, double-wall, 1/8 inch minimum. Single handle release. Integral rectangular 1/4 cab shield, see-through design. Slanted flatbed dump hitch plate ICC bumper with 2.5 inch receiver style hitch, 20,000 lbs. rating with D rings. Buyers #1809070 or acceptable alternate. Rear of receiver tube shall be equal to rear plane of body +/- 2 inches. 7-pin RV trailer plug. Stop/turn/tail lights mounted in corner posts, all LED lighting. All electrical connections must be weather sealed. Mud flaps behind rear wheels and anti-sail brackets. Install factory rear camera kit. One (1) frame mounted and sealed 18x18x30 inch heavy duty aluminum toolbox on each side between cab and and rear wheels. Specifications for Subframe Hoist NTEA class 20 minimum Double acting, scissor type with 12 VDC electric over hydraulic power unit 50 Degree minimum dump angle Lifting capacity 12,000 lbs. minimum Heavy duty pendant style control, routed to interior of cab Safety lock bar(s); Body with Installation Transportation- vendor required to pick up truck chassis from City of Iowa City Equipment Shop (1200 S Riverside Drive) and return trucks to same location upon completion.
