15' elliptical steel dump body with 50” integral sides, 52"- 54" end and 52"- 54" head: 15 to 17 yard capacity, partial length fenders, stainless steel rear corner bolsters bottom rear bolster and tailgate linkages. Hoist shall be NTEA Class 110 trunnion mounted, chrome or double nitrited, telescopic 32 ton cylinder hoist operated by central hydraulic system, and shall be double acting. Accepted cylinders shall be a Mailhot CS140-5.5-3DA or a Marathon M63138. Greaseable rear hinge. Box shall be mounted on truck chassis to allow box to be fully raised and so spreader will not hit rear tires and spinner will not drag on the ground. Box shall have foldable steps accessible from steps on fuel tank, incorporated on left front corner of dump body. Two steps on inside left front corner of box. Grab bars installed at steps. Hooks welded on tailgate to store tailgate chains when not in use. Body safety struts, positive lock style (two total - one on each side). Dump body corner post enclosures, bolted or pinned at bottom of corner post. Made out of No. 304 or No. 201 stainless steel.; Floor - constructed out of 3/16" AR400 or HARDOX 450 high tensile steel. Western style formed long sills with no cross members.; Sides & Ends - 3/16" AR400 or HARDOX 450 high tensile steel.; Heavy duty tailgate; air trip operated; 52"-56" high horizontal braced tailgate; 3/16" AR400 or HARDOX 450 high tensile steel.; Stationary 22” - 24” cab shield - window cut in vertical section, cab shield shall be bolted to wing cross over tube allowing for easy removal and installation. Top flat portion of cab shield must be higher than front top edge of box with a rubber flap mounted to top front edge of box to close gap between cab shield and box.
