CHASSIS Current Model Year Freightliner Low-profile M2 Chassis Yes___ No___ Bidder to supply the specifications in their response outlining the detailed specification of the chassis they are providing. Disconnect mechanical, electrical, and medical systems between chassis and module; lift module from chassis and position to allow full inspection of under structure Supply and install a new Reyco Granning rear air suspension for heavy truck Add towing capabilities to the chassis that meet the City of Detroit Police Department requirements New bellows between cab and module, add cover to top and bottom Components not scheduled for replacement on cab will be cleaned and inspected prior to reinstallation; metal finish parts will be cleaned and polished; components will be installed with non-electrolytic gaskets or barriers and fastened with marine grade stainless steel screws Seal interfaces to eliminate air and water leaks; grommets and silicone will be used at harness and hose access ports Install new OSHA-compliant backup alarm with cancel switch for silent backing; locate cancel switch on master control console; back up alarm system to reset to "on" mode when the transmission is taken out of reverse; alarm shall be a Precco or equivalent with minimum 97 dB Install two (2) drive shaft loops Install heat shields as needed Disconnect mechanical, electrical, and all systems between chassis and module; full inspection of under structure Inspect exposed structural framing, welds, tie down braces and gussets for cracks, warping, excessive wear and corrosion; minor damage will be repaired; excessive damage discovered will be reviewed with customer Inspect electrical system, 125 VAC system Test heating, air conditioning, and ventilation system Inspect door hinges, handles, and pins; quote replacement if necessary Yes___ No___ Yes___ No___ Yes___ No___ Yes___ No___ Yes___ No___ Yes___ No___ Yes___ No___ Yes___ No___ LIFTGATE Widen lift gate to fit new robot (robot is 30" wide and gate will need to widen approx 1" Yes___ No___ ADDITIONAL CABINET Add cabinet to rear of vehicle to hold misc. equip (shovels, etc) Yes___ No___ IN/OUT ACCESS Add inside/outside to access two (2) compartments. Add doors and all necessary equipment Yes___ No___ ADDITIONAL CABINET – STREETSIDE, REAR Add interior to cabinet to pass side rear to match "sister" vehicle
