Specifications include, but are not limited to: City of Columbus needs to obtain hardware and installation of listed items. These items shall be installed on Two (2) City Provided 2025 Ford Police Interceptor Unit. The following features are required: Havis console part number C-VS-1012-INUT-2-H or equivalent angled console with top plate for rear HVAC controls 2 Havis side mounted arm rests Havis dual cup holder Havis 6inch deep accessory pocket Setina polycarbonate partition Part number PK0228ITU20TM Setina full replacement transport seat with cargo area rear partition and center pull seatbelts, part number QK0566ITU20 Setina dual prisoner transport partition part number 2K0035ITU20RPFRTM Setina window barriers for rear seat windows Part number WK0514ITU20 TecNiq prisoner area dome light 2.5lb Fire extinguisher and vehicle mount to be mounted in trunk area out of the way. Whelen item number ISFL50Z or equivalent two piece inner windshield mounted emergency light unit with red/blue strobes. Rear hatch window lights, Whelen ION SOLO lights, one red, one blue Flasher to strobe the tail lights Whelen PCC6W1 switch control center, 6 separate functions to control lights and siren Whelen Alpha SL remote siren or equivalent mounted at the front of the vehicle behind the grille. Whelen projector 100 watt composite speaker rated at 122dB or equivalent with mounting bracket and hardware Window tint package for front windows and brow tint on windshield One Axon Fleet 3 refresh wiring kit. Part number 100150 Installation of strobe and flashing lights to one switch with proper fuses, circuit breakers, and sealed wiring Installation of siren to on/off switch for wail and yelp functions and momentary switch for air horn function. All installations must be completed by a certified Whelen master technician All wiring shall be soldered and sealed with weathertight heat shrink. Wires shall be secured in place with wire loom and clamps as needed to secure in place All wire pass through holes shall be protected by rubber grommets to prevent chaffing Installation work must be done in accordance to Original Equipment Manufacturers (OEM) standards/specifications All installations must follow the Ford Vehicle Up-Fitter’s Guide
