Specifications include, but are not limited to: The Cage and Rack Washer will replace an existing pit-mounted two-door pass-thru unit. The Cage and Bottle Washer will replace an existing floor mounted two door pass-thru unit. Delivery, installation and local startup is requested for both units. Separate mobilization fees are required as the department will not take both units offline at the same time. Item A: Cage and Rack Washer Requirements for a steam heated unit with incoming water approximately 120F • Approximate Interior Cabinet Size: 48” wide by 88” high by 90” long o Two door pass-thru o Service enclosure/trim and door fascia only required on dirty side o Controls to be located on the right side of the unit’s dirty side • Existing wall opening is approximately 83” wide by 101” high • Pit mounted o See attached drawing of existing pit • 480V 3-phase, 60Hz • Steam coil sump heating • Data stored on removeable flash memory • Interlocking doors Item B: Cage and Bottle Washer Requirements for a steam heated unit with incoming water approximately 120F • Approximate interior cabinet size: 48” wide by 30” high by 34” deep o Two door pass-through • Existing wall opening is approximately 60” wide by 87” high • Floor mounted • 480V 3-phase, 60Hz • Data stored on removeable flash memory • Alkaline and Acid compatible • Steam coil sump heating • Any accessories/options required for bottle/cage washing • Delivery & installation • Local startup
