ASBP MH65 Engine Shop Upgrade Requirements
Required
- Cabinets and toolboxes must be modular
- Upper cabinets must not attach to any walls (self-contained)
- Two of the cabinets must be tall two door with shelving
- There must be three toolboxes
- Two of the smaller toolboxes must be rolling and have the ability to be stored within the cabinet system.
- Any upper cabinets must have the ability to have under cabinet lighting
- All 3 wall units must have multiple power outlets to facilitate test equipment
- On the larger system, there must be a cabinet for hose reels
- The system must include a sink as per shop requirements
- There must be an additional four short cabinets for mounting on an upper shelf for test equipment storage
- Cabinets must be black with black hardware
- Cabinets must be aluminum for maximum corrosion prevention
- Toolboxes must have a locking mechanism
- Drawers must not have individual drawers stops that are not apart of the drawer pulls. Either the drawer pull themselves must pull up to allow for drawer movement or the unlocking mechanism is attached the pull itself (underneath is preferred).
- There must be a double stacked drawer cabinet for parts storage
- All of the bottom cabinets (other than the two tall and double stacking parts storage) must be the same height for facilitating long cabinets tops (butcher block or composite)
attached dimensions drawing of the shop these will be installed in.
The cabinets that will be mounted on the shelving system will go above the sink wall, please include the same cabinets that are on the sink wall for the shelving as well.
for build design, please contact:
Stratten Swanner (501) 472-6241 Stratten.S.Swanner@uscg.mil
Contracting Officer: Justin Hinkle (808) 842-2822 justin.n.hinkle@uscg.mil
Place of delivery: Attn:Z20255, 443 South 134th place, Tukwila WA 98168
