Specifications include, but are not limited to: 5-Ton SGTR Crane: Provide and install one 5-ton single girder crane, Model ASI-SGTR-RM 25.5, CMAA Class ‘C’ 10,000lb capacity. See the detailed drawings for span measurements. 20/3.2 FPM hoisting speed see detailed drawings measurement of available lift. 65 FPM 2-step VFC trolley speed and 100FPM 2-step VFC bridge speed. 208/3/60 mainline voltage, 115-volt controls. Mainline contactor, bridge panel disconnect. See detailed drawings. Geared upper and lower limit switch. Independent sliding push button pendent. Williams wireless remote system consisting of two transmitters, one receiver and OSHA required signaling device Rigid ‘C’ track with flat cable festoon system. Overload protection system device set at 110 percent. Runway Rail: 1) Provide and install see detailed drawings for measurement of 40lb runway rail system complete with see detailed drawings for LF 40lb punched rail, splice bars with hardware, hook bolts with hardware and end stops. Electrical: Provide and install see detailed drawing for measurements of four conductor 110-amp runway electrification system complete with beam brackets, conductor hangers, see detailed drawings for LF of conductor bar, center power feeds, end caps and tandem articulating collector assemblies. Load Test: Perform operational and OSHA load testing at the time of installation with test weights. Manuals: Current repair manual covering all components. Current parts catalog covering all components. Two (2) operator’s manuals shall be provided.
