Specifications include, but are not limited to: Aluminum Bear Trap - up to 5 - Trap: • Dimensions: 42 Inches wide and 8 foot long • Aircraft quality aluminum 50-52 tensile strength • Color: Brown • Rear Gate w/ pully system for a remote door opener to allow personnel to release bear safely. System must be designed to allow personnel to pen release door from the safety of the truck cab. Door made of .125 aluminum reinforced with 2”x2” x.188 and 1.5” x 1.5”/188 aluminum angle, measuring 40 ¼’’ x 40’’, guide by 2 ½’’ x 2 ½’’ x /188 and by 1 ½’’ x 1 ½’’ / .250 aluminum angler, lined with UHMW slides, including a window barred by ¾’’ x 6061 aluminum rounds with a darting port and a covering so it may be closed. The bars must be 1.75 inches apart and the darting port size 2.25 inches wide by 3.75 inches high. The door must have a locking mechanism for setting the trap and when the door closed upon capture. The door guide must fold. • One (1) access 12’’ square access hatch with top hinges and locks that open out only. The bars must be 1.75” apart and the darting port size 2.25” wide by 3.75 inches high. • A water pan minimum of 2 gallons shall be welded inside the trap at the rear with a 1-inch drain hole with rubber stopper and a fill hole. Sharp edges must be rounded. • Six (6) 1’’ ventilation holes in the top. Sharp edges must be rounded. • Two (2) air scoops to funnel air into trap while in transport. • A tripping mechanism. • Six (6) 1’’ drain holes in the bottom. Sharp edges must be rounded. • One 14’’ x 14’’ window on the back side of trap with window barred by ¾’’ x 6061 aluminum rounds and a darting port. Window must also have a covering, so it may be closed. • Side port in the middle of each side, 8 inches high and 10 inches wide with a darting port. Each must have a covering, so it may be closed. • A serial number shall be permanently applied to a visible location • Manufactures statement of origin shall be provided for licensing purposes • Danger warning shall be permanently affixed to each side of the trap • The body of the trap shall be constructed of smooth (not corrugated) aluminum • Traps shall be able to be locked open or closed by means of padlock.
