Specifications include, but are not limited to: 4x4 DIGGER DERRICK CAB AND CHASSIS - QUANTITY: Two (2). DESCRIPTION: New standard model 4x4. Cab to axle 136” for a usable 130” CA. Center of rear axle to end of frame 96”. GVWR 37,000#. Front axle 14,000#. Rear axle 23,000#. This vehicle will be used for the installation of a hydraulic digger derrick. All systems on this vehicle must be compatible for this application. This vehicle will be working in right-of-way areas (off road) – No low-profile front frame/grills allowed. DETAILS: 350 HP diesel-powered engine minimum, 1,000 lbs. ft. torque minimum with heavy-duty cooling system to include auxiliary transmission cooling (8.7L size of engine minimum). Electric engine shutdown, key switch operated. 120 volt block mounted electric engine coolant heater. Allison automatic transmission with 10 bolt PTO opening with PTO gear, 3000 RDS model. Transmission gear selector located on dash. Allison WT spare input/output capable of 70 mph. Vertical exhaust system to be routed to the curbside cab corner. Heavy-duty front bumper with two (2) tow hooks. Clean frame rails for body builder and clean back of cab (vertical exhaust pipe allowed). 14,000# front axle rating capacity. 14,000# front suspension. 23,000# capacity rear axle with the ability to attain a highway speed of 65 mph. 23,000# rear leaf spring suspension with auxiliary springs. Driver activated locking differential. One (1) 50-gallon street-side fuel tank. Frame section modulus 26.8 – reinforced full-length frame rails...
