Specifications include, but are not limited to: • Create a template of the existing molding and casings. • Protect all surfaces that are not being repaired from dust, dirt, and debris to prevent unnecessary damage. • Protect adjacent rooms from dust migration. • Removal of existing material damaged by water to the surface of the brick wall substrate at the two exterior walls from corner to corner and from the top of the chair rail to the ceiling level. • Remove all plaster window trim to the interior face of the wood windows from the top of the plaster arches to the windowsill level. Remove the plaster cornice trim completely on these two walls to the ceiling level. Remove damaged plaster at the ceiling on the western side of the room. Remove at least 12 sqft of plaster to the substrate. • Allow one month for the area to dry and for investigation of the substrate condition before replacing the plaster. • Installation of new moldings and casings to the areas where the original molding and casings were removed. All new moldings and casings shall match the existing throughout the building. • Paint the new plaster surfaces in a minimum of three coats using SW LOXON Concrete and Masonry Primer/Sealer, or approved equal, in color to match existing surfaces. Product substitutions must be approved by the State prior to the award. • Disposal of material shall be the responsibility of the Vendor and shall be at the Vendor’s expense. • Clean floor, ceiling, and walls after completion of the work.
