Specifications include, but are not limited to: Contractors shall understand and follow manufacturer’s recommendations. Work shall include but is not limited to the following: 1. All safety devices will be cleaned, overhauled and adjusted as necessary. 2. All furnaces and heat exchangers will be cleaned and inspected. 3. All controls will be cleaned and calibrated. 4. All electrical connections will be inspected and tightened if required. 5. All corroded components will be cleaned and reported. 6. All units will be started to ensure trouble-free operations. 7. All heating equipment will be fired, tested and adjusted for maximum efficiency. 8. All burner assemblies will be cleaned and adjusted as specified by the manufacturers’ specifications. 9. All filters will be replaced with pleated filters 10. All motors, bearing, valves and other equipment requiring lubrication will be cleaned, lubricated and adjusted. 11. All motors, pumps, fans couplings, seals and mounts will be inspected and adjusted by October 31st of each year of the contract. 12. Drive belts will be inspected and replaced as required. 13. Defective and inoperative equipment will be identified and reported immediately to Contract Administrator.
