Specifications include, but are not limited to: • All ratings and capacities shall be per S.A.E. Standards for the BASE machine specified with mfgr pin-on; 2.75 CY. general purpose bucket and tires specified • Loader to be equipped with Z-Bar • Loader to be equipped with a fixed drawbar and tie-downs. • H.D. Rear Bottom Guard. • Vandal protection equipment must include keyed alike locking engine hood and side covers, locking fuel and coolant access doors (if so equipped), and locking cab doors. If fuel filler is located outside engine hood or panels, a locking fuel cap shall be furnished. If battery box is located outside it must be lockable and keyed alike • Ride control • Unit to be equipped with an American Coupler System Pro Series 2000 quick hitch fully operated from inside the cab. One (1) extra female blank shall be provided with each machine • A mechanical or electric backup alarm shall be furnished • Hydraulic pump(s) shall be provided for loader implements. (Min. of 39 GPM) at engine’s rated RPM • Loader controls shall be joystick control • Unit(s) to be equipped with wireless machine monitoring system as standard equipment with a secure, web based, application to be used by the State for reviewing machine location, usage and maintenance data such as hour meter readings, all warnings, and monthly activity for a period of 10 years from in service date. State will determine in service date. ENGINE: • Diesel, Tier IV Final, 6 cylinder, 4 cycle, water cooled. • Engine to be designed and built by manufacturer. • Minimum SAE J1349- 130 net HP, maximum 145 net HP at rated RPM or ISO9249-minimum 130HP, maximum 155 net HP at rated rpm. • Air filter with centrifugal pre-cleaner and condition indicator. • Fuel filter with water separator. • Cold start to -20 without the use of ether. Ether start aid will not be accepted. • 110 volt block heater. • Reversible engine cooling fan. • Auto Idle and auto shut down. TRANSMISSION: • Full power shift or hydrostatic drive, manually operated. • Minimum 4 speed ranges forward and 3 reverse. • Top speed forward to be minimum 20 MPH and top speed reverse to be minimum 15 MPH. • Loader must be capable of being shifted from one speed range to another including forward and reverse at working speed without the use of an operator controlled clutch. • Speed ranges may be accomplished by gear reduction, multi-stage torque converter, or a combination of both...
