Specifications include, but are not limited to: Work consists of providing new office cabinetry and countertops and their installation in the Seward County Treasurer Office in the Seward County Administration Building located at 515 N. Washington, Liberal, Kansas. A. Base Cabinets. 1. Provide and install two (2) sets of base cabinets to match existing base cabinets. Cabinets to be installed on the south and west walls. 2. Provide 4” toe kick under base cabinets. 3. Verify adequacy of backing and support framing for cabinet installation B. Upper Cabinets 1. Provide and install two (2) sets of upper cabinets. 2. Each set of cabinets shall consist of three (3) 36” wide x 32” tall two (2) door cabinets with 2 adjustable shelves per cabinet. 3. Cabinets shall be installed with bottom of cabinet @ 19” above finished countertop height. C. Custom Cabinets. 1. Two (2) cabinets custom built to fit existing openings approximately 32” wide x 22” deep x 8’6” height and 42” wide x 22” deep x 8’6” height. County Treasurer to provide specific design in regards to cabinet design for doors, shelving, rods, etc. Countertop. Provide and install countertops for each set of base cabinets. Countertop to be continuous and provided with backsplashes at back and sides of countertops that abut vertical surfaces. SPECIFICATIONS Cabinets: 1. Cabinets shall be birch veneered lumber for all exposed horizontal and vertical surfaces. 2. Shop Finishing: Grade-Premium AWI Finish System #2: Catalyzed lacquer-shop finish Stain: 200 Spiced Walnut Sheen: Satin Seal internal and semi-concealed surfaces 3. Drawer guides shall be roller carriage bottom mounted with epoxy coated finish with a 75-pound rating, 4. Adjustable shelf supports shall be heavy duty nylon designed for installation in pre-drilled holes in cabinet sides. 5. Hinges shall be heavy duty self-closing institutional type with dull chrome finish. 6. Pulls to be 4” U-shaped surface mounted to match existing pulls in office cabinetry. Countertop: 1. Countertops shall be high pressure laminate bonded to ¾” particle board core 1 ½” thickness minimum. 2. Laminate shall be MADRIS INDIAN SLATE 3688-77 manufactured by Formica. In the event product is unavailable Owner shall specify manufacturer and style.
