Specifications include, but are not limited to: I. PLOW GEAR a. Tilting front Hitch: Set ahead on the frame so the hood will open without tilting the hitch. b. Hydraulic front post, bolted to Head Gear, completely welded( NOT ANGLED) c. Hydraulically detachable rear post and hydraulic push arms with 3-wheel stand with remote joystick control for removal. The joystick needs to be wired in and functional d. 11’ Quick switch dustpan plow e. Seven gauge 12’ wing double cover blades wing quick-release program required. Hydraulically activated for shelving, remote joystick rear controls for ease of removing wing f. The hydraulic system will include a variable displacement load sense pump with min. size 1310 series u-joints on pto shaft, six-section valves mounted in a stainless steel enclosure, must have relief valve junction blocks to ease removal of blade and wing g. Cirus Sander Controls with twin joysticks for functions ( Same as SPW #20) h. Stainless steel hydraulic piping to both front and rear w/SS fittings throughout i. Hydraulic couplers for all removable attachments to match SPW fleet j. Stainless Steel 40-gallon (min.) behind the cab style oil reservoir with low oil sensor shutdown and tank heater (300 watt max) k. Plow and wing to have a combined maximum swath of 13’6” clearing path l. All body subframes, plow parts, and associated hardware to be mounted on the frame or where metal-to-metal contact is apparent shall be primed and painted black prior to installation on the truck. No unprimed and painted steel parts will be accepted. This is required to minimize rust formation from wet salt and chlorides. No Exceptions II. LIGHTING: WHELEN AND TRUCK-LITE [all LED] The lighting system will include LED heated lens plow lights and two LED driving lights, five LED work lights, two LED work lights to the rear at the lower corner of the dump body, two additional LED backup lights to the rear also at the lower corner of the dump body, and one LED work light for the wing on the rear wing tower. Whelen LED warning lights consisting of 2 L31 beacons mounted to the headboard, one green and one amber, and 2 700 series rear light heads (warning, backup, turn/tail/brake), warning lamps to be amber on one side and green on the other. LED marker lights in all ICC & DOT spots on the body. Provide a parts list with wiring diagrams for all lighting installed. All LED lighting is required to match SPW's current fleet. III. BODY a. Beau-Roc DH 14’ Dump body (or equivalent) with 42” sides, 54” Double Acting Tailgate, 3/16” Smooth Side Hardox 450 sides, b. Body to include air tailgate, single-acting telescopic hoist, ½ cab shield. US Tarp w/aluminum arms and power rollup controlled from cab solenoid in the cab for weather protection. The body is to be painted Gloss Black. c. Vibco Big Bertha body vibrator, installed between body rails on added plate per Vibco instructions d. Pintle plate with 25-ton Pintle hook 26” off the ground to the center of carry position, with D rings e. Two sets of mud flaps with stainless anti-sails fore and aft of rear wheels. Rears will swing hang similar to SPW #20, Poly rear fenders f. Air brake plumbing to rear for trailer hook-up mounted through the side of the frame rail. g. An aluminum toolbox with a hinged lid/door will be bolted to the left frame rail. Its dimensions are 24” W x 12” H x 12” Deep. h. Remote grease lines for the lift cylinder to the right side of the truck
