Specifications include, but are not limited to: a. Minimum requirement: Wet Sleeve, turbo-charged inline 6-cylinder b. Horsepower: 425 peak HP c. Torque: Minimum of 1400lb at 1000 rpm d. Equipped with a minimum 9-gallon DEF heated tank e. Air cleaner: Single element, air restrictor gauge mounted in the cab f. Block heater: 120 volt/1150 watt, wired to outlet under cab drivers door w/spare power pigtail for additional heater g. Radiator: Crossflow series system, charge air cooler with transmission cooler h. Starter motor: 12-volt i. Alternator requirement: 12 volt, 160 amp capacity, Bosch pad mount j. Batteries: Minimum (4) group 31, 12 volt, a minimum of 3600 cold-cranking amps k. Exhaust: Single stack mounted on right-hand side of cab. Exhaust turnout on top of stack. Forward enough for wing post installation. l. Fuel tank: Top draw, 80-gallon w/steps. Round, non-polished aluminum with quick connect outlet mounted on left side, with SS straps. Under the cab with steps. Fuel lines nylon tubing with O-ring Snap-On quick connect fitting at both ends. m. Engine brake switched in the cab (exhaust style not acceptable) n. Engine PTO shaft under, not through, radiator o. Air compressor: 15.7 cfm (minimum) p. Coolant filter: Spin-on type, mounted in the engine compartment q. Throttle: Hand control electronic to raise the engine off an idle when parked r. Governor: Electronic road speed type s. PTO drive flange: to include adapter plate on the engine t. Engine oil pan shall be powder coated to prevent rust-through, Winter Package with Y cord from socket in standard location. u. Cowl cover in wiper area to prevent snow build-up v. Stainless Steel Oil Pan w. Aluminum after treatment cover
