Specifications include, but are not limited to: 1) General Specifications a) Unit must have JRB 416 Pattern Hydraulic Coupler Tool Attachment (or supplied adapter) b) Unit shall be equipped with 20.5 R 25 tire with multi-piece rims c) Machine full turn 40 degrees tipping load with standard Z-bar linkage with Pin-on GP Bucket with bolt-on edge, 2.75 cu yd with tire deflection shall be at least 18,208lb. (8,259kg) d) Machine full turn 40 degrees tipping load with standard Z-bar linkage with Pin-on GP Bucket with bolt-on edge with NO tire defection 2.75 cu yd shall be at least 19,742 lb. (8,959 kg) e) Front tires shall be covered with fenders f) Easily accessible remote start battery terminals g) The counterweight shall be built in h) The unit will be provided with a hitch with locking pin i) Unit shall have an articulation locking bar j) Unit shall have vandal protection with lockable engine enclosures, filler access for radiator/fuel/DEF/hydraulic/transmission Unit shall be provided with a loader boom service locking bar k) Bucket break out force shall be no less than 24,406 lbs. with manufacturers standard Z-bar with pin-on 2.75 cu yd pin on bucket and standard configuration 2) Frames and Structures a) Machine front frame shall be of a 4-plate design of four vertical plates extending from boom pivots pins reaching to the front axle to distribute boom loads on the axle. The design is superior to the two-plate frames b) Loader bucket bell crank linkage shall be fabricated of high strengthen steel for increased durability and strength over castings. 3) Engine a) Engine shall be certified to EPA Final Tier 4/EU Stage IV b) Engine shall have a wet-sleeve cylinder liner design for improved cylinder cooling over dry sleeve and cast-in-bore design for improved cylinder and piston ring durability c) Engine displacement shall be no less than 6.8 liters (414 cu. In.) d) Engine net power shall be no less than 152hp (113KW) at 1,800RPM e) Engine shall develop at lease a 60% torque rise and should have at least a 504 lb. ft. net peak torque at 1,100 RPM
