Specifications include, but are not limited to: To improve voice uplift and intelligibility for all seating areas, improve sound cues for stage performance, and improve interconnect performance and ease of operation. Equipment outline: 1. Removing and replacing sound reinforcement speakers. 2. Installing Digital Signal Processing 3. Installing Digital Control Systems 4. Installing new Source inputs and destinations 5. Update the existing video system Speaker Replacement: Remove the existing overhead speaker system and replace it with two-line array speakers mounted on the left and right side of the stage area. The exact mounted bracket will need to be determined by the installer. Amplifier Replacement: Remove and replace analog amplifiers with two digital Dante connect amplifiers. Stage monitors would be connected to a single two-channel Dante connect amplifier. The amplifier locations would need to be determined by the installer. The stage monitors envisioned would be mobile and placement could be determined as needed. Adding Digital Signal Processor and Mixing control: Both mixing and digital control are envisioned for ease of operation. A 64-channel mixing console to have individual-level control for each of the body pack microphones. The mixing console can load software-controlled digital processing eliminating the need to purchase separate pieces of equipment. There is also software to control the mixer remotely from tablets or laptops. A separate digital processor would be used to incorporate the final mix into the amplifiers and would be used to set level controls for speakers. The mix control device will need to have 64 Dante channels as well as 12 channels of Analog inputs/outputs. The DSP controller would also add 32 channels of Dante in the final mix.
