Specifications include, but are not limited to: Example of Manufacturers: Stahl, Omaha, Reading, Knapheide, Auto Crane SERVICE BODY SPECIFICATION Understructure to be 11-gauge 50,000-PSI yield steel channel minimum or equal. Floor to be 12-gauge minimum steel tread-plate. Doors to be double panel 20-gauge exterior and interior steel construction minimum. Side to be A-40 or equal galvannealed steel. Shelves to be 18-gauge galvannealed steel minimum including shelf dividers. Door Seals to be automotive quality type to keep out dust and water, no weather stripping. Locks to be keyed alike, flush mounted, paddle, rotary style, slam action, or tee handle and removable for repair or replacement. Door Hinges to be corrosion resistant and removable for repair or service. Tail Gate to be slam-action style; pickup-bed style release handle in center of gate with 500 lb capacity. Fuel fill cup to be recessed and corrosion resistant. Multiple configurations of body to be of eligible users order of manufacture options. Complete underside of box to be undercoated and sealed to reduce corrosion. As per pictures (shown in section VI), the cabinets should be the same on both sides of chassis. The shelving should be: Front cabinet: two horizontal shelves (three sections) Middle cabinet: one horizontal shelf (two sections) Rear cabinet: one horizontal shelf (two sections) 84” CA chassis will have additional cabinet at front with two horizontal shelves (three sections) LIGHTING All lighting to be LED. LIGHTS to have rubber grommets and to meet all Federal Motor Vehicle Safety Standard FMVSS and STATE requirements with sealed wire harness. BUMPER SPECIFICATION Bumper with receiver to be class 4 minimum and engineered and approved for the application and type from the manufacturer. PAINT The units shall be E-coated or powder coated including insides of compartments, except for, rubber and those metallic accessories or fixtures constructed of rust-resistant or plated material not normally painted.
