- One 10 ft. Stainless Steel Tripod with grounding kit. Campbell Model CM110 - One 4 ft. Sensor Cross-arm with one CM210 mounting kit. Campbell Model CM204 - One weather resistant 14” x 16” inch Enclosure, Campbell model ENC14/16-SC-MM-NA (SC 1 Conduit for cables, MM tripod mass mounting, NA no installed addition) - One 20W Solar Panel with 15’ ft. cable ( w/tinned wires and standard mounting kit) Campbell model SP20-PT-SM - One 12 volt Power Supply with charging regulator (-40 to 60 C) and 7Ah sealed rechargeable battery. Campbell model number PS150 - One 10 amp, 10ft external battery cable Campbell model 34040 - One Texas Electronics Rain Gauge with 8 inch orifice and 0.01” inch (0.254 mm) tipped. 20’ ft. cable with tinned wires. Model #TE525WS-L20-PT. - One Rain Gage Mounting kit Campbell model CM270 - One Vaisala Temperature/RH probe with 10 ft tinned cable Campbell model number HMP60- L10-PT - One Metspec 6-plate solar radiation shield Campbell model number RAD06 - One 30 inch Digital Barometer (-40 to 60 C) Campbell model number BAROVUE10 - One Sierra Wireless Airlink, 4G Industrial LTE Cellular gateway North America/EMEA, No data provisioning. Campbell model number RV50X-NE-ND - One RV50(X) Mounting Kit Campbell Model 32252 - One 4G/3G Directional 9DBI MIMO Cellular Antenna with 2 type N Female. Campbell model number 38485 - Two Bulkhead Surge protection installed in enclosure, Type N to SMA, 700-2700 MHz, 18”inches long. Campbell model number 31315. - Two Antenna Cable RG8 with 2 Type N Male Connectors-10 with 10 ft per cable. Campbell model COAXNTN-10. - One Apogee SP-110-SS Pyranometer-10 with 10ft per sensor, PT with tinned wires. Campbell model CS301-10-PT. - One Apogee Solar Sensor Mounting Stand with level & base. Campbell model number CM226. - One Wind Monitor with 10 ft cable per sensor-PT with tinned wires. Campbell model number 05103-L10-PT. - One Nurail Crossover fitting, 1x1 inch. Campbell model number 17953. - One Measurement and Control Data Logger (No additional coms, -40 to +70 C deg, 3 yr warranty, Campbell calibration) Campbell model number CR1000X-NA-ST-SW-CC - One CPI/RS-232 RJ45 to DB9 male cable, 1 ft long. Campbell model number 31055 - One set of two RS_232 to Datalogger control port cables, 2 ft long. Campbell model number SC110 - One Null Modem Cable with 9-pin male to male, 1ft long. Campbell model number 18663
