GROUND MOUNT TS 2 CABINET: Product ID 51050 Ground mount assemblies shall include: One (1) TS 2 Power Supply One (1) Solid State, Type III, Two-Circuit Flasher Eight (8) Flash Transfer Relays Sixteen (16) Load Switches Four (4) 12-Position Field Terminal Strips Two (2) 4-Channel Loop Detector Cards Two (2) 16-Channel, TS 2 Detector Card Racks One (1) 16-Channel Solid State Malfunction Management Unit 2 (MMU2) Four (4) Bus Interface Units (BIUs) One (1) Global Positioning Device (GPS) and Cable Assembly Additional Equipment and Hardware as Specified Herein The ground mount cabinet shall measure (44” to 46” W) x (67” to 77” H) x (24” to 26” D) and have a fully open bottom. These are outside dimensions exclusive of hinges, doors, handles, overhangs, vents, and adapters. Cabinet heights are measured to the lowest point of the top of surface of the cabinet. The bottom of the cabinet shall have enough surface clearance around the bottom edge to fit four (4) 5/8” concrete anchor bolts, centered at least 1-1/2” from the edge, in each corner. POLE MOUNT TS 2 CABINET: Product ID 51060 Pole mount cabinet assemblies shall include: One (1) TS 2 Power Supply One (1) Solid State, Type III, Two-Circuit Flasher Six (6) Flash Transfer Relays Twelve (12) Load Switches Three (3) 12-Position Field Terminal Strips One (1) 4-Channel Loop Detector Card One (1) 16-Channel, TS 2 Detector Card Rack One (1) 16-Channel Solid State Malfunction Management Unit 2 (MMU2) Three (3) Bus Interface Units (BIUs) One (1) Global Positioning Device (GPS) and Cable Assembly Additional Equipment and Hardware as Specified Herein The pole mount cabinet shall measure (30” to 36” W) x (52” to 62” H) x (16” to 18” D). These are outside dimensions exclusive of hinges, doors, handles, overhangs, vents, and adapters. Cabinet heights are measured to the lowest point of the top of surface of the cabinet. The bottom of the cabinet shall have two (2) holes, one (1) 3-1/2” to 3-5/8” and one (1) 1-1/4” to 1-3/8”. Each hole shall be provided with a National Pipe Thread (NPT) Myers hub. See Figure 1. Pole mount cabinets shall be provided with two (2) C-shape cabinet mounting brackets and a permanently installed reinforcement plate. The mounting brackets shall be pre-attached with bolts to the back of the pole mounted cabinet reinforcement plate. Brackets must have slots for ¾” banding material and reinforcement plate must be designed to support the weight of the cabinet and the equipment intended to be contained within.
