To create and install a customized truck bed for an AZGFD-owned F600 truck and install an AZGFD-owned (fish) tank onto the customized truck bed. AZGFD-owned F600 Truck is 4x4 with 169” wheel base and a cab to axle of 84” 3.1 Truck Bed: 3.1.1 Bed must be 144 inches (12 feet) long by 102 inches wide. 3.1.2 Bed must be made from aluminum w/diamond plate non-skid surfaces. 3.1.3 Bed shall have fold-up aluminum catwalk on passenger side that is approximately 9.75" wide, running the full length of the bed (see picture). 3.1.4 Bed shall have a fold-up catwalk secured by rubber tie-down (see picture). 3.1.5 Bed shall have a fold-up aluminum ladder in the read driver’s side to allow for access. 3.1.6 At the front of the bed, a two-piece, custom pipe cradle shall be created to fit a 6 ft. long, 15-inch diameter aluminum pipe. 3.1.7 A spare tire rack shall be mounted on the driver’s side, just aft of the oxygen-bottle cut-out. 3.1.8 Headboard shall be approximately 55 inches tall by 90 inches wide using aluminum diamond plate material. 3.1.9 Headboard shall have a minimum of three (3), 3” diameter aluminum tubes (12 inches long) to be mounted vertically on headboard (24" apart) for vertical storage of nets and brooms (slide the handles in the tubes). 3.1.10 Headboard shall have two (2) very-bright LED lights to be mounted to the top of the headboard facing backwards (one on driver’s side, other on passenger side). 3.1.11 LED headboard light shall be wired into the truck’s toggle switch. 3.1.12 LED marker lights to illuminate the driver’s side, passenger side, and rear; All recessed into the bed. Marker lights to be activated by headlight switch.
