The following Specifications are the minimum requirements. All Bidders should make every effort to make a site visit to verify measurements and power ratings before bidding. This build will also require the hopper on the tipping floor to be replaced as well. The bidder will be responsible for acquiring the proper measurements for the hopper. 1. General Compactor Specifications: 1.1. Dimensions – 356” overall length x 88” overall width x 77” overall height 1.2. Clear Top Dimension – 124” x 75” 1.3. Discharge – 81” wide x 60” high 1.4.Ram Penetration – 46” 2. Performance Specifications: 2.1. Ram Force – 142,392 lbs Normal / 230,675 Max Boost 2.2. Ram Cylinders – (2) 7” bore x 5” rod cylinders x 168” long 2.3. Ram Cycle Time – 32 seconds 3. Hydraulic Specifications: 3.1. System Pressures – 1850 psi Normal / 3000 psi Max Boost 3.2. Pump Capacity – 156 gpm multistage (68/54/34) w/ Regen Hydraulics 3.3. Reservoir Capacity – 350 gallons Reservoir capacity – 350gal with internal baffles to provide cooling capability without the use of a separate circulation pump and heat exchanger 3.4. 5HP Cooling System w/ Kidney Loop 4. Electrical Specifications: 4.1. UL listed panel box (NEMA 3R or Higher) 4.2. Operation Voltage – TBD , 3ph 4.3. Control Voltage – 120V / 24 VDC 4.4. Motor – 60 HP, Tri-volt motor, 3 phase 4.5. Power Unit Operating System – Koyo Click PLC 4.6. Standard Controls on remote pendant control and power unit 4.7. Standard Controls include key start switch, red mushroom E-stop button(top and bottom), reverse button, 80% full warning light (top and bottom), 100% full light (top and bottom) 5. Body Construction: 5.1. Packer Sides – 3/8” Plate with 3/8” AR-400 plate liners in the charge box area. Liners are plug welded to allow removal and replacement. 5.2. Packers Sides – Each side reinforced with (1) 6” x 3” x 3/8” structural tube top, 6” Channel uprights mounted vertically and strategically spaced down the length of the machine, (2) 6” x 3” x 3/8” tubes to be mounted vertically at front corner for reinforcements. 5.3. Rear cylinder support – constructed of a minimum of 12” x 3” x 3/8” rectangular tubing. A middle support is provided.
