The Dishwasher Equipment shall meet or exceed the following minimum requirements: 1. Hobart FT 1023e-BASE-BD or equivalent Electrical Electrical and grounding connections must comply with the applicable portions of the national electrical code and/or other local electrical codes. 15KW Electric Booster with Circuit Breakers Motors, Controls, Power Rinse and Booster Heat Wash, Dual Rinse Heat, Blower Dryer Heat and Blower Service wire temperature rating: 90C. Min. SCCR 5KA Plumbing Connections must comply with applicable sanitary, safety, and plumbing codes. Drain and fill line configurations vary, some methods are shown on the reference drawing. Common Hot Water Connection with Automatic Fill, 110F Water Minimum Common Drain Connection; Two Drain Locations; May be drained to either end of unit. Plug opposite end. Building flowing hot water pressure to the dishwasher is 30-35 PSI. Building flowing cold-water pressure to the dishwasher is 30-35 PSI. Water hammer arrestor must meet ASSE-1010 standard or equivalent, to be supplied, if required, in hot and cold water supply lines at service connection. Ventilation Vent stack assembly can be temporarily removed from the energy recovery or base units to yield (81-7/8”) clearance for doorways on standard height units. Vent Connection, must fit inside 16” diameter vent stack, providing 750 CFM exhaust at machine connection at .75” water column, with back draft preventer. Vent fan control – Switch contacts, max. Current 1.5 AMPS.
