HD modular steel construction with corrosion resistant powder-coat finish o Powder-coat shall be as an industry standard 2.5 mils in film thickness allowing for good weather resistance according to AAMA 2603 and salt spray resistant to 2,500 hours. o All steel components shall be white metal blasted or equivalent. Designed and tested to push debris up to 150 lbs. at 20 mph in the deployed (down) position. Quick-disconnect vehicle specific mount direct to frame. 3/4" rubber contact face to protect device during debris removal and allow unit to be used as push bumper when in the stowed position. Air flow provisions in moldboard and wings for host vehicle’s cooling system. Hydraulically raise/lower device from single push-button handheld controller with cradle. Indicator light in dash alerts driver that device is not in the stowed (up) position. o This device is designed to operate in FLOAT mode while deployed to follow contours of the road surface. o Controller has lights indicating when unit is in FLOAT mode. o The controller automatically allows the device to coast to a soft stop. This results in smoother operation and decreased wear on the hydraulic system. Hydraulically adjustable wings mounted to left and right of moldboard to contain debris when deployed and to contour to vehicle when stowed. o Wings deploy simultaneously with single push-button control. o Secured to moldboard with full height 1” hinges with removeable pins and grease fittings. o The wings are 35° from the maul board when stowed. They travel 75° to their fully deployed position. When fully deployed, they are 40° from the maul board. these angles have a +/-5° tolerance. Bolt-on replaceable scraping edge with wear indicator. Camera view system with 170° wide-angle lens, 1080p HD resolution and external infrared. 7" touch-screen color HD monitor with audio. Camera mounted top center of device to view moldboard blind spot by driver. Additional rear facing camera and windshield mounted forward facing camera with digital video recording system. All cameras should be able to be recorded by this device. Computer-controlled safety deployment limiter to not allow deployment over 20 mph. Fitment is for Ford F450 equipped with heavy service front suspension or snow-plow prep packages. Vehicles not equipped with these options may require replacement front suspension springs. Device must include in-cab safety sheet and manual. Dimensions: o Wings Stowed 88" o Wings at Half-Extension 96" o Wings Fully Deployed 84" o 39" from bottom of the blade to the top of the grille. o Weighs 650lbs. o When in the stowed position, the device is 8.5" from the ground, 5.5" from the vehicle fender, and 2.5" from the vehicle grille.
