Suzuki DF150A Outboard: Horsepower: 150 hp Engine type: Outboard 4-stroke Full Throttle RPM Range: ~5000-6000 Ignition System: Solid State Direct Ignition Alternator: 12V (44 Amp minimum) Fuel induction system: EFI C.A.R.B. rating: 3-star Starting system: Electric Trim: Power Trim and Tilt Shaft length: 25” (X:25) Weight: 535 pounds maximum Warranty: 36 month governmental/state agency minimum Additional Items and Installation: 2 stainless steel 4 blade propellers (~17-18 pitch, current prop is 18p 4 blade) 1 new fuel line from OBM to fuel tank 1 control box with throttle and shift cable and wiring harness mounted to boat 1 engine switch panel (key and safety switch), unless part of the control box 1 Suzuki 4” tachometer with “monitor” feature mounted to boat helm (see photos of current tach. placement and control box bracket). Mounting: Installation of new motor on transom, and installation of all applicable accessories, including but not limited to control box, gauges, cables, panels, modules, wires, and steering controls. Hydraulic Steering (Dometic) on boat will be re-used, (Currently attached to 150 hp Mercury See photos), appropriate plates/brackets etc. if needed should be included in quote for new engine mounting to hydraulic steering. Remove current motor and controls/gauges/oil reservoir etc. Vendor will place removed motor that is currently on boat, and its accessories, into the back of state vehicle (pickup truck). Must be installed within 120 days after PO issued. If supplier if greater than 25 miles from office include pickup and delivery, unless install occurs onsite. Notes: Trim extender/reducer plates are currently installed to reduce porpoising with current engine (see photos) . o be installed on KANN deck boat with engine setback and jackplate (see photos)
