1. Dimensions 1.1 Height – Acceptable range - Fifty-five and three eighths (55 3/8") inches up to sixty-seven (67") inches. 1.2 Width – Acceptable range thirty-four and three eighths (38 3/8") inches up to thirty-nine (39") inches. 1.3 Depth – Acceptable range thirty-eight and seven eights (38 7/8") inches up to forty-four (44") inches. 2. Design 2.1 Must have front loading capability. 2.2 Front door must have a clear glass insert, centered. 3. Load capability 3.1 Must be capable of washing loads up to sixty-five (65) pounds. 4. Electrical Requirement 4.1 Must have 208/230 Volt 60hz 1 phase hardwired capability. 5. Construction 5.1 Stainless Steel. 5.2 Door must have hinges on the left side so door swings outward and to the left. 6. Temperature Range 6.1 Washing Machine must be able to handle water temperatures of a minimum 160 degrees (160°) degree Fahrenheit. 7. Time Cycle 7.1 Thirty (30) Preprogrammed cycles. 8. Water Inline Hookup 8.1 Three fourths (3/4") inch water line hookup for hot and cold water. 9. Detergent Compartment 9.1 Four (4) compartment supply dispenser for dry or liquid chemical. 10. Drainage 10.1 Three (3) inch water drain. 11. Spin Cycle 11.1 Minimum of two hundred (200) G-Force extraction. 12. Chemical Injection System 12.1 Minimum of five (5) inlet lines. 12.2 Connection to lines must be fit one fourth (1/4") inch plastic pipping. 13. Motor 13.1 Motor must be of sufficient Horsepower (HP) to safely operate loads of up to sixty-five (65) pounds. 14. Miscellaneous 14.1 The washer must come with the ability to be bolted down to a concrete floor and come with manufacturer recommend hardware. 14.2 Contractor will be responsible for the repair/remediation of previous anchoring locations, and ensuring that any new anchoring locations drilled will not impact or be impacted by previous bolt/anchor locations. 14.3 Contractor will be responsible for repair of any damage to work environment in order to keep facility compliant with Fire/Life Safety Code. 14.4 Contractor will ensure that all connections to facility plumbing, and electrical service are hard service rated and meet the specifications of Idaho plumbing/electrical codes. 14.5 Facility drain pit requires that there be a 5" minimum steel riser fastened to the bottom of the installed equipment to allow for proper drainage. This gives a clearance of 13" from floor to bottom of drainpipe.
