A2.1 Brand and Model: Freightliner M2 106 Plus Vendor must meet or exceed the specifications listed below. The following specifications will apply to both the tandem and triaxle dump trucks. A. Data Version 1. SPECPRO21 Data Release Version 045 B. Vehicle Configuration and General Service 1. M2 106 Plus Conventional Chassis 2. Set Back Axle – Truck 3. Trailer Towing Provision at the end of frame with SAE J560 4. Gross Axle Weight (GAW): a. Front: 20,000-pound minimum b. Rear: (2 x 23,000) 46,000-pound I-Beam type suspension 5. LH Primary Steering Location 6. Truck/Trailer Configuration 7. Domiciled, USA (Excluding California and Carb Opt-In States) 8. EPA Emissions Certification for Registration in EPA or ACT states – EPA Clean Idle (includes 6 x 4-inch label on lower forward of driver door. 9. Utility/Repair/Maintenance Service 10. Dirt / Sand / Rock Commodity 11. Terrain / Duty: 100% (All) of the time, in transit, is spent on paved roads 12. Maximum 8% Expected Grade 13. Smooth Concrete or Asphalt Pavement – Most severe in-transit (between sites) road surface 14. Medium Truck Warranty 15. Expected front axle(s) load: 20,000 lbs. 16. Expected rear drive axle(s) load: 46,000 lbs. 17. Expected gross vehicle weight capacity: 66,000 lbs. 18. Expected gross combination weight: 80,000 lbs. C. Truck Service and Tractor Service 1. Expected body/payload CG height above frame “XX” inches: 32.0 inches 2. Van Trailer 3. Single (1) Trailer
