The Service Body will be installed on a 2024 Dodge Ram 5500 dual rear tires with a cab to axle length of eight-four inches (84 in.). The vehicle is purchased and located at our Nampa location noted in Attachment 1, section 2 A if additional measurements are needed. Appointments can be made to measure the vehicle by contacting the RFQ solicitation contact. The following Specifications are the minimum that IDFG is willing to accept. Reading Master Mechanic MM225VP, or equal Must have a corrosion resistant steel body, white in color. Body Length, eleven (11) feet. Body Width – ninety-six (96) inches wide. Cargo width- must have a minimum cargo width of fifty (50) inches. The cargo floor must have a non-skid surface. Cargo area must have a minimum of six (6) tie downs integrated into the floor. Crane compartment must have a minimum reinforcement rated for a twenty-five thousand (25000) foot pound crane. First and second road and curbside Compartments on left and right must be a minimum of sixty (60) inches tall and twenty-eight (28) inches wide. First and second road and curbside Compartments on left and right must contain five (5) drawer units and two (2) adjustable shelves. Drawer units must have individual drawer locking handles. Drawers must be built on a minimum of four hundred (400) pound capacity slides. The horizontal center compartment on left and right must be a minimum of twenty (20) inches tall by forty-six (46) inches wide. Center compartments must contain a bolt bin. The rear compartment on both left and right side must be a minimum of twenty-four (24) inches wide and forty-six (46) inches tall. The rear compartment must contain two (2) fully adjustable shelves. All compartment doors must be flush mounted with hidden hinges. All compartments must have a minimum of a three (3) point locking system. All compartments must have led lighting for low light content visibility. The service body must have manual in-out, up-down outriggers. The service body must have four (4) led exterior work lights with three hundred and sixty (360) degree rotation mounted on the front-back, left right corners. The service body must have a minimum twenty (20) inch workbench style storage bumper with an incorporated two (2) inch receiver and d-ring safety hooks Receiver hitch must have a minimum sixteen thousand (16,000) pound weight rating. The service body must have a minimum tailgate height of fourteen (14) inches. The service body must have a minimum eighth (1/8) inch treadplate overlay on top of the body and front of compartments. The service body must have a backup camera installed.
