ITD Owned Truck Model Item 1- One (1) New 2025 Ford F350 4WD 60CA cab and chassis, SRW (Single Rear Wheels), gas. Electrical Circuit Breakers All electrical components must be protected by circuit breakers. OE circuit breakers must be utilized if provided and; A power disconnect switch must be installed between the truck and the Service Body. Location will be inside truck cab within reach of the driver seat. Wiring Must be continuous and must not be spliced without utilizing weather pack connectors; Must be securely fastened and located away from all pinch points; Must be clamped and held in place using stainless steel rubber-insulated, bolt-on cushion clamps; Passing through bulkheads must be protected with either rubber or neoprene bulkhead wire protectors and/or body grommet type insert; Must be run in chemical resistant looms and; Must have wire identification every six (6) in. Striped wire of assorted colors is acceptable. Cabling Must be of adequate size to handle the anticipated loads of all electrical components; All cabling must be uninterrupted and complete with no splices; Terminal ends must be crimped and soldered to the cables and sealed with polyolefin heat shrink tubing. Scotch-Loc fasteners, crimp butt connectors, and wire nuts are not acceptable for any connection; Weather-pack connections must be protected with dielectric grease and; All electrical cabling to lamps must be stress relieved within six (6) in of the lamp. Switches OEM switches are to be used unless other arrangements are made with ITD. All switches must illuminate in the ON position and be sealed (weather tight) and; Switches must be labeled with a permanent placard.
