Specifications include, but are not limited to: GENERAL SPECIFICATIONS: Y N 1. GVWR – 52,000 Lbs. Y N 2. GVWR front axle - 12,000 with 71.5” from center of kingpin to center of kingpin and shock absorbers. Y N 3. GVWR Rear axle - 40,000 Y N 4. Cab to Axle/Trunnion – 138-140 inches Y N 5. Overhang trunnion to end of frame 80 inches Y N 6. Frame RBM (each channel) 2,100,000 Y N 7. Rear suspension, tandem, Hendrickson HMX Haulmaxx, 54 inch spacing with shock absorbers Y N 8. Hubs to be iron only. Y N 9. Gear ratio to be decided by company that is awarded the bid and the Fleet Maintenance Director. Y N 10. Brakes to meet current federal stopping requirements. Y N 11. Full air brakes Y N 12. Brake chambers, spring, both rear axles parking. Y N 13. Pull cable type drain valves for air tanks. Y N 14. Parking brake controlled by yellow knob, located in instrument panel or dash. Y N 15. Spring brake modulator valve. Y N 16. Brakes (front) = Disc HD. Severe service rotors and brake pads. Y N 17. Brakes (rear) = Disc HD, Severe service rotors and brake pads. Y N 18. ABS Antilock brake system, 6S6M and electronic traction control. Y N 19. Bendix heated air dryer with spin on filter cartridge. WABCO System Saver Spin On System will be accepted. If WABCO System is provided, diagnostic software must be provided to Fleet Maintenance. Y N 20. U-joints minimum 1710
