Specifications include, but are not limited to: 1. Engine/ Emissions Emission compliant Turbocharged Diesel Engine Minimum 250 gross horsepower @ 2100 RPM Minimum of 428 cubic inches Displacement Minimum 900 lbft. gross Torque @ 1300 RPM Final Tier 4 emission package with EGR cooler, DOC, and SCR system. Mounted to allow for access to top of engine. Loader shall be equipped with automatic engine regeneration allowing machine to operate without interruption. Shall also be equipped with a means of manual activation when required without affecting workability. Engine Block heater 120v. 2. Cooling System Cooling system shall be isolated from the engine compartment by a non-metallic shield. Cooling system shall hold at least 15.6 gal (59 L). 3. Transmission Machine shall have 5 forward speeds and 3 reverse speeds Machine shall have an electronic power shift countershaft transmission. Machine shall have standard lock-up Clutch Torque-Converter to allow increased speeds when roading or climbing ramps. Machine shall have an Electronic Clutch Pressure Control to modulate clutch engagement individually to allow smoother speed and directional shifts. Machine shall have a variable shift control that allows the transmission to upshift at lower engine RPM’s. Maximum forward/reverse travel speed not to exceed 25 MPH ______________________ 4. Servicability Machine shall have well protected, easily visible sight gauges for transmission oil, hydraulic oil, and radiator coolant. A hydraulic/electric lift cylinder with manual back up shall be standard to open the hood. If necessary the entire hood shall be removable using built in lift points. With the hood closed, quick checks on engine oil and coolant sight gauges can be completed without requiring the hood to be raised. Panels behind the tires shall lift up and can be removed for additional access. The hood shall allow for easy access to the front and rear faces of the radiator and other coolers for easy cleaning. A perforated and corrugated grill shall minimize debris buildup and shall swing out for easy cleaning and access to the cooling cores. Cab air filters shall be accessible from the outside of the cab. Grease fittings shall be grouped in no more than two locations on the same side of the machine. Auto lube shall be available for precise, auto lubrications of pins and bushings. Please List pricing for this option. Master shut off switch shall be housed in a protected accessible panel. Safety equipment and all lighting shall be as required to meet Federal, State of Wyoming, and OSHA regulations. The winning vendor shall supply a complete set of filters for each unit. (All required filters) 5. Tires Radial 23.5 R25 L3 minimum
